Strauss Elektroakustik SE-PA-100 Stereo Power Amplifier

Stereo Amplifier – Analog HGBT audio amplifier with high gain and bandwidth: High Gain Bandwidth Technology

$9,499.00

-

12-Month Special Financing**

SKU: STRSTRAUSSSEPA100 Category: Tag Brand:

Description

HGBT HIGH GAIN BANDWIDTH TECHNOLOGY
The objective of linear power amplification is well recognized by professional audio amplifiers: the shape of the electrical voltage at the input should appear proportionately larger at the output – any deviation is distortion.

If a loudspeaker (dynamic transducer) is connected to a power amplifier carrying the audio signal, an exchange of electric currents begins, because the loudspeaker as a linear motor develops an electromotive force which makes it appear as a generator or voltage source. These voltages generated periodically by the loudspeaker and the corresponding currents flowing back into the amplifier are, by design, deformed to a greater or lesser extent by linear and nonlinear distortions.
In order to achieve the above-mentioned goal of linear power amplification, the regulation of the power amplifier must be able to suppress the loudspeaker electrical audio signals and their linear and non-linear distortions.

Based on measurements with linear and non-linear loads and based on listening tests of different power amplifiers, the output resistance has proved to be a critical parameter: it should be as low as possible over the entire frequency response.

With regard to the quality of the bass reproduction, this is no new insight. What is new, however, is the importance of this parameter for the clearly audible distortion in the mid-high range and in the wide range of sonic micro- and macrodynamics, contour, plasticity and spatial impression in the whole spectrum.

In particular for high frequencies and for large signals, the requirement of the lowest possible output resistance of the audio amplifier enforces the most efficient control, the technical feature of which is a high GBP gain bandwidth product.

The HGBT high-gain bandwidth technology of the SE-PA-100 is a particularly powerful control technology for very low output resistance, very low distortion and very low noise. In fact, the power bandwidth of the SE-PA-100 is 1.7 MHz, limited only by an input filter to 5 Hz – 130 KHz (-3 dB).

– Analog HGBT audio amplifier with high gain and bandwidth: High Gain Bandwidth Technology
– Output stage with bipolar high-performance transistors – Very low output resistance
– Very high power bandwidth
– Very low noise
– Very low distortion and intermodulation
– Soft clipping
– Power buffer for all stages of voltage and current amplifications
– Regulated power supply for international AC mains voltage connection
– Aluminum housing with 10 mm wall thickness as a fully grounded block
– Convection cooling; no fans
– Loudspeaker connections with low transition resistances

RATED POWER OPERATED
90 Watt RMS into 8 Ohms; both channels

LOAD IMPEDANCE
8 – 16 Ohms (do not use 2 – 4 ohm loads)

SOA
Current limiting and temperature protection

FREQUENCY RESPONSE
5 Hz – 130 KHz (- 3 dB); ref. 1 KHz, 0 dB

SIGNAL-TO-NOISE RATIO
– 96 dB / 1W into 8 Ohms; 20 Hz – 30 KHz
– 100 dB / 1 W into 8 Ohms; A-weighted
– 119 dB / 90 W into 8 Ohms; A-weighted

THD + NOISE INTERMODULATION DISTORTION
0.006 % / 1 W into 8 Ohms; 20 Hz – 30 KHz
0.0007 % / 1- 50 W, 8 Ohms; CCIF/DFD 19+20 KHz

OUTPUT IMPEDANCE
0.003 Ohms to 0.006 Ohms
20 Hz – 20 KHz, 1 W into 8 Ohms

DAMPING FACTOR
2800 — 100 Hz / 1 Watt into 8 Ohms
2800 — 1 KHz / 1 Watt into 8 Ohms
1400 — 10 KHz / 1 Watt into 8 Ohms
1400 — 20 KHz / 1 Watt into 8 Ohms

INPUT RESISTANCE
3 KOhms balanced XLR
1.5 KOhms asymmetrical RCA

INPUT SENSITIVITY
0.93 volts for rated power
XLR: differential voltage 0.93 V
RCA: input voltage 0.93V

VOLTAGE GAIN
29.6 dB

AC MAINS VOLTAGE POWER CONSUMPTION
100 – 240 VAC; + / – 10 %; 50 – 60 Hz
Min. 100 W (standby); Max. 400 W

FUSE
100 – 110 VAC 8A slow
230 – 240 VAC 4A slow

DIMENSIONS & WEIGHT
height 31 cm, width 32 cm, depth 31 cm
23 kg

Don't see what you're looking for?

We carry all of the top brands for audio and post-production, so don’t hesitate to contact us if you need something specific!

Westlake Pro Card

No Interest if paid in full within 12 Months**

On qualifying purchases made with your Westlake Pro credit card. Interest will be charged to your account from the purchase date if the promotional purchase is not paid in full within 12 Months. Minimum monthly payments required.

**No interest will be charged on the promo purchase if you pay it off, in full, within the promo period. If you do not, interest will be charged on the promo purchase from the purchase date. The required minimum monthly payments may or may not pay off the promo purchase by the end of the promo period. Regular account terms apply to non-promo purchases and, after the promo period ends, to the remaining promo balance. For new accounts: Purchase APR is 29.99%. Minimum interest charge is $2. Existing cardholders: See your credit card agreement terms. Subject to credit approval.

book a consultation

Contact Westlake Pro’s Design Services Group for a free consultation about your next project.

Apply For A Lease From
All Media Capital

Insider Access to Pro Audio's hottest deals, new gear, and free software.

We hate spam. We don’t share your information with any third parties.

Sign up now!